myloader.h 5.16 KB
Newer Older
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176
/*
 *  Copyright (C) 2006-2008 Gabor Juhos <juhosg@openwrt.org>
 *
 *  This program is free software; you can redistribute  it and/or modify it
 *  under  the terms of  the GNU General  Public License as published by the
 *  Free Software Foundation;  either version 2 of the  License, or (at your
 *  option) any later version.
 *
 */

#ifndef _MYLOADER_H_
#define _MYLOADER_H_

/*
 * Firmware file format:
 *
 *	<header>
 *	[<block descriptor 0>]
 *	...
 *	[<block descriptor n>]
 *	<null block descriptor>
 *	[<block data 0>]
 *	...
 *	[<block data n>]
 *
 *
 */

/* Myloader specific magic numbers */
#define MYLO_MAGIC_FIRMWARE	0x4C594D00
#define MYLO_MAGIC_20021103	0x20021103
#define MYLO_MAGIC_20021107	0x20021107

#define MYLO_MAGIC_SYS_PARAMS	MYLO_MAGIC_20021107
#define MYLO_MAGIC_PARTITIONS	MYLO_MAGIC_20021103
#define MYLO_MAGIC_BOARD_PARAMS	MYLO_MAGIC_20021103

/*
 * Addresses of the data structures provided by MyLoader
 */
#define MYLO_MIPS_SYS_PARAMS	0x80000800	/* System Parameters */
#define MYLO_MIPS_BOARD_PARAMS	0x80000A00	/* Board Parameters */
#define MYLO_MIPS_PARTITIONS	0x80000C00	/* Partition Table */
#define MYLO_MIPS_BOOT_PARAMS	0x80000E00	/* Boot Parameters */

/* Vendor ID's (seems to be same as the PCI vendor ID's) */
#define VENID_COMPEX		0x11F6

/* Devices based on the ADM5120 */
#define DEVID_COMPEX_NP27G	0x0078
#define DEVID_COMPEX_NP28G	0x044C
#define DEVID_COMPEX_NP28GHS	0x044E
#define DEVID_COMPEX_WP54Gv1C	0x0514
#define DEVID_COMPEX_WP54G	0x0515
#define DEVID_COMPEX_WP54AG	0x0546
#define DEVID_COMPEX_WPP54AG	0x0550
#define DEVID_COMPEX_WPP54G	0x0555

/* Devices based on the Atheros AR2317 */
#define DEVID_COMPEX_NP25G	0x05e6
#define DEVID_COMPEX_WPE53G	0x05dc

/* Devices based on the Atheros AR71xx */
#define DEVID_COMPEX_WP543	0x0640
#define DEVID_COMPEX_WPE72	0x0672

/* Devices based on the IXP422 */
#define DEVID_COMPEX_WP18	0x047E
#define DEVID_COMPEX_NP18A	0x0489

/* Other devices */
#define DEVID_COMPEX_NP26G8M	0x03E8
#define DEVID_COMPEX_NP26G16M	0x03E9

struct mylo_fw_header {
	uint32_t	magic;	/* must be MYLO_MAGIC_FIRMWARE */
	uint32_t	crc;	/* CRC of the whole firmware */
	uint32_t	res0;	/* unknown/unused */
	uint32_t	res1;	/* unknown/unused */
	uint16_t	vid;	/* vendor ID */
	uint16_t	did;	/* device ID */
	uint16_t	svid;	/* sub vendor ID */
	uint16_t	sdid;	/* sub device ID */
	uint32_t	rev;	/* device revision */
	uint32_t	fwhi;	/* FIXME: firmware version high? */
	uint32_t	fwlo;	/* FIXME: firmware version low? */
	uint32_t	flags;	/* firmware flags */
};

#define FW_FLAG_BOARD_PARAMS_WP	0x01 /* board parameters are write protected */
#define FW_FLAG_BOOT_SECTOR_WE	0x02 /* enable of write boot sectors (below 64K) */

struct mylo_fw_blockdesc {
	uint32_t	type;	/* block type */
	uint32_t	addr;	/* relative address to flash start */
	uint32_t	dlen;	/* size of block data in bytes */
	uint32_t	blen;	/* total size of block in bytes */
};

#define FW_DESC_TYPE_UNUSED	0
#define FW_DESC_TYPE_USED	1

struct mylo_partition {
	uint16_t	flags;	/* partition flags */
	uint16_t	type;	/* type of the partition */
	uint32_t	addr;	/* relative address of the partition from the
				   flash start */
	uint32_t	size;	/* size of the partition in bytes */
	uint32_t	param;	/* if this is the active partition, the
				   MyLoader load code to this address */
};

#define PARTITION_FLAG_ACTIVE	0x8000 /* this is the active partition,
					* MyLoader loads firmware from here */
#define PARTITION_FLAG_ISRAM	0x2000 /* FIXME: this is a RAM partition? */
#define PARTIIION_FLAG_RAMLOAD	0x1000 /* FIXME: load this partition into the RAM? */
#define PARTITION_FLAG_PRELOAD	0x0800 /* the partition data preloaded to RAM
					* before decompression */
#define PARTITION_FLAG_LZMA	0x0100 /* the partition data compressed with LZMA */
#define PARTITION_FLAG_HAVEHDR  0x0002 /* the partition data have a header */

#define PARTITION_TYPE_FREE	0
#define PARTITION_TYPE_USED	1

#define MYLO_MAX_PARTITIONS	8	/* maximum number of partitions in the
					   partition table */

struct mylo_partition_table {
	uint32_t	magic;	/* must be MYLO_MAGIC_PARTITIONS */
	uint32_t	res0;	/* unknown/unused */
	uint32_t	res1;	/* unknown/unused */
	uint32_t 	res2;	/* unknown/unused */
	struct mylo_partition partitions[MYLO_MAX_PARTITIONS];
};

struct mylo_partition_header {
	uint32_t	len;	/* length of the partition data */
	uint32_t	crc;	/* CRC value of the partition data */
};

struct mylo_system_params {
	uint32_t	magic;	/* must be MYLO_MAGIC_SYS_PARAMS */
	uint32_t	res0;
	uint32_t	res1;
	uint32_t	mylo_ver;
	uint16_t	vid;	/* Vendor ID */
	uint16_t	did;	/* Device ID */
	uint16_t	svid;	/* Sub Vendor ID */
	uint16_t	sdid;	/* Sub Device ID */
	uint32_t	rev;	/* device revision */
	uint32_t	fwhi;
	uint32_t	fwlo;
	uint32_t	tftp_addr;
	uint32_t	prog_start;
	uint32_t	flash_size;	/* Size of boot FLASH in bytes */
	uint32_t	dram_size;	/* Size of onboard RAM in bytes */
};


struct mylo_eth_addr {
	uint8_t	mac[6];
	uint8_t	csum[2];
};

#define MYLO_ETHADDR_COUNT	8	/* maximum number of ethernet address
					   in the board parameters */

struct mylo_board_params {
	uint32_t	magic;	/* must be MYLO_MAGIC_BOARD_PARAMS */
	uint32_t	res0;
	uint32_t	res1;
	uint32_t	res2;
	struct mylo_eth_addr addr[MYLO_ETHADDR_COUNT];
};

#endif /* _MYLOADER_H_*/