- Jul 07, 2015
-
-
blogic authored
Signed-off-by:
Roman Yeryomin <roman@advem.lv> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46243 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
bluetooth is separate from 802.11 entries too Signed-off-by:
Dirk Neukirchen <dirkneukirchen@web.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46242 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Signed-off-by:
Sven Eckelmann <sven@open-mesh.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46241 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Signed-off-by:
-
blogic authored
This changes makes it possible to store custom settings in individual files inside the directory /etc/sysctl.d/. Signed-off-by:
Stefan Tomanek <stefan.tomanek+openwrt@wertarbyte.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46239 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
This device is identical to the TL-WR740N v5, it even uses the same HWID (which wasn't the case for older TL-WR741ND revisions). Signed-off-by:
Matthias Schiffer <mschiffer@universe-factory.net> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46238 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Backport for the Spansion S25FL164K It's a 8 MiB flash chip with 4 KiB erase sectors. Signed-off-by:
L. D. Pinney <ldpinney@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46237 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
This patch adds support for the Bitmain Antminer S3 Cryptocurrency Miner http://wiki.openwrt.org/toh/bitmain/s3 Signed-off-by:
-
blogic authored
Signed-off-by:
Alexander Couzens <lynxis@fe80.eu> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46235 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
rocket-m titanium is a device based on ar9344 with 802.11af poe. It doesn't use the SoC wifi, instead it's using an ar9280 connected to the pci bus. The gps version of the rocket-m ti is working, but gps is untested. The gps is connected to the first serial port. Signed-off-by:
-
blogic authored
Add features ext4 targz to target x86/xen_domu in order to generate images in defconfig. This fixes #18074. Signed-off-by:
Luiz Angelo Daros de Luca <luizluca@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46233 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Signed-off-by:
Alexandru Ardelean <ardeleanalex@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46232 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Signed-off-by:
-
blogic authored
Signed-off-by:
-
blogic authored
Signed-off-by:
-
blogic authored
This patch enables sysupgrade for the Bitmain Antminer S1 Signed-off-by:
-
blogic authored
The designated blue WAN port on both devices has index 5, not 1. Signed-off-by:
Christian Beier <cb@shoutrlabs.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46227 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
NB that wlan5g is phy0tpt and wlan2g phy1tpt. Signed-off-by:
-
blogic authored
uboot-lantiq: Add support for Arcadyan ARV8539PW22 (Speedport W 504V) Signed-off-by:
Jannis Pinter <jannis@pinterjann.is> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46225 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
lantiq: Add support for Arcadyan ARV8539PW22 (Speedport W 504V) Signed-off-by:
-
blogic authored
u-boot support depends on the next "upstream" version ([0]) from Daniel Schwierzeck. Since the installation process is quite complicated a "how to" was added to the wiki: [1] [0] https://github.com/danielschwierzeck/u-boot-lantiq/tree/openwrt/v2014.01-next [1] http://wiki.openwrt.org/toh/bt/homehub_v5a V2: Use the correct PCI interrupt (fixes 2.4GHz wifi) Signed-off-by:
Martin Blumenstingl <martin.blumenstingl@googlemail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46223 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Basically the only error I am seeing is "Correctable Error". Also newer lantiq PCIe drivers have this message wrapped in a "if debug enabled" block. So it should be safe to disable this warning. Signed-off-by:
-
blogic authored
Newer DSL driver versions depend on the address information. Signed-off-by:
-
blogic authored
This is useful if the device also has an ethernet WAN interface with a separate mac address (that is derived from the LAN mac address). Signed-off-by:
-
blogic authored
Make it consistent with the net_device struct and the xrx200 driver Signed-off-by:
-
blogic authored
Signed-off-by:
-
blogic authored
Signed-off-by:
-
blogic authored
All (still relevant) patches were refresh. The following patches were dropped because they are applied upstream: - 0003-MIPS-lantiq-handle-vmmc-memory-reservation.patch - 0005-MIPS-lantiq-add-reset-controller-api-support.patch - 0006-MIPS-lantiq-reboot-gphy-on-restart.patch - 0009-MIPS-lantiq-command-line-work-around.patch - 0010-MIPS-lantiq-export-soc-type.patch - 0011-lantiq-add-support-for-xrx200-firmware-depending-on-.patch - 0037-MIPS-lantiq-move-eiu-init-after-irq_domain-register.patch Signed-off-by:
-
blogic authored
Signed-off-by:
Konrad Kotowicz <skoti1@go2.pl> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46215 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Fix typo in WHR1166D mtd size variable Signed-off-by:
Lorenzo Bianconi <lorenzo.bianconi83@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46214 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
rmilecki authored
Signed-off-by:
Rafał Miłecki <zajec5@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46212 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
cyrus authored
When enabled the dnsmasq DHCP server allocates the IP addresses sequentially starting from the lowest available IP address. Signed-off-by:
Hans Dedecker <dedeckeh@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46211 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
cyrus authored
Signed-off-by:
-
nbd authored
Signed-off-by:
Petko Bordjukov <bordjukov@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46209 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
nbd authored
Signed-off-by:
Miaoqing Pan <miaoqing@codeaurora.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46208 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
nbd authored
Patch cherry-picked from the following location: https://www.codeaurora.org/cgit/quic/qsdk/oss/system/openwrt/commit/?h=release/coconut_ioe4531_2.0&id=5c357bf6c763e4140dddcc9a3bc5f005525a9c0e Changelist, - add more register defines - add EHCI support - fix GPIO pin count to 18 - fix chained irq disabled - fix GMAC0/GMAC1 initial - fix WMAC irq number to 47 - merge the changes of dev-eth.c from the patch to file. Signed-off-by:
-
nbd authored
ar71xx: fix ethernet initialization on QCA953x-based boards (TP-Link TL-WR841N/ND v9, Compex WPJ531) The initialization routines for these boards were relying on some (wrong) defaults for the QCA953x ethernet. Make these defaults explicit to prevent breaking them when the QCA953x defaults are fixed. Signed-off-by:
-
- Jul 06, 2015
-
-
hauke authored
reorder some parts of the patch to remove the declaration-after- statement warning. Signed-off-by:
Hauke Mehrtens <hauke@hauke-m.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46205 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
hauke authored
The new version now works with kernel 4.1 Signed-off-by:
-
hauke authored
unregister_netdevice_many() was extended in this commit to also delete unreg_list: https://git.kernel.org/cgit/linux/kernel/git/backports/backports.git/commit/?id=97666f936e0656a1b28c40cc33981a8db65e1a11 This patch is no longer needed. Signed-off-by:
-
