- Nov 23, 2014
-
-
nbd authored
Signed-off-by:
Felix Fietkau <nbd@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43342 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
- Nov 22, 2014
-
-
jogo authored
Move compatible strings from board structs into separate table. This allows for several board compatibles to match to the same board in case e.g. only the flash size / partitions differ. Signed-off-by:
Jonas Gorski <jogo@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43341 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
- Nov 21, 2014
-
-
nbd authored
Signed-off-by:
-
nbd authored
Signed-off-by:
Rafał Miłecki <zajec5@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43339 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
wigyori authored
Signed-off-by:
Zoltan HERPAI <wigyori@uid0.hu> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43338 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
wigyori authored
Signed-off-by:
-
- Nov 20, 2014
-
-
rmilecki authored
Signed-off-by:
-
nbd authored
Signed-off-by:
-
nbd authored
We should make sure that also for ar8216 hw gets initialized. For ar8216 hw_init is a dummy currently. The hw_init used for ar8236 should be generic enough to be usable with ar8216 too. Signed-off-by:
Heiner Kallweit <hkallweit1@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43334 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
nbd authored
Move the PHY fixup call to the PHY init loop. Use ar8xxx_has_gige in the PHY init instead of passing the gigE capability via function parameter. Signed-off-by:
-
- Nov 19, 2014
-
-
nbd authored
Kernel 3.14 introduced a switch reset in phy_init_hw in drivers/net/phy causing BMCR_ANENABLE to get cleared. Due to the fact that ar8xxx_phy_config_aneg does nothing for PHY 0 autonegatiation support remains disabled. This can cause ports to operate at 10MBit/half-duplex only. Fix this by calling genphy_config_aneg for PHY 0 too as genphy_config_aneg sets BMCR_ANENABLE if it's not yet set. Fixes: ticket 17800 Signed-off-by:
-
nbd authored
PHY init code in the switch-specific hw_init functions is mainly identical. Factor it out into a generic ar8xxx_phy_init function. Signed-off-by:
-
nbd authored
Move phy fixup code from the chip-specific hw_init functions into a fixup_phys callback. Signed-off-by:
-
nbd authored
Currently there is a fixed 1000ms wait time after the switch was reset. Most if not all switches need much less time to perform a reset. Therefore replace the fixed wait time with polling for BMCR_RESET to be cleared. Signed-off-by:
-
nbd authored
All supported switches have 5 PHYs. Currently partially 5 is hardcoded and partially switch-specific constants exist. Replace them with a global constant. Signed-off-by:
-
nbd authored
Signed-off-by:
-
nbd authored
Signed-off-by:
-
nbd authored
Signed-off-by:
-
nbd authored
Signed-off-by:
-
nbd authored
On out-of-tree modules depending on other out-of-tree modules from a different tree, module dependencies are not filled properly. This change helps with adding those dependencies in the AutoLoad call Signed-off-by:
-
rmilecki authored
Signed-off-by:
-
blogic authored
wg302v1_fixup() looks for the ATAG_CMDLINE atag, it doesn't find it and so it takes the last atag in the list and overwrites non allocated memory. The side effects are corrupted vital data and a kernel that doesn't boot. More details here https://dev.openwrt.org/ticket/18356 The fix appends the fixup to the command line and updates the atag only when it finds it. Signed-off-by:
Gianluca Anzolin <gianluca@sottospazio.it> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43320 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Few notes: - redboot partitions are unusable - redboot declares only 16M of RAM, hence the mem arg in cmdline and separate kernel config - boots fine but only ethernet works for now - split wiliboard and raidsonic boards into different subtargets Signed-off-by:
Roman Yeryomin <roman@advem.lv> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43319 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Building current trunk with 3.18 kernel fired some errors like 'missed dependancy of module XXX from library kmod_YYY.ko'. These patch fixes 3 of such issues which are critical to have a successful build. Signed-off-by:
Alexey N Vinogradov <a.n.vinogradov@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43318 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Signed-off-by:
Alexander Couzens <lynxis@fe80.eu> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43317 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jogo authored
r37490 removed the actual driver but left the kmod definition intact, causing the build system hapily creating an empty package for it. Remove it also to not make it seem as if it still exists. Signed-off-by:
-
jogo authored
ldd might be called for shell scrips during sysupgrade, causing it to complain that they are not a dynamic executables. This is a harmless error, so supress it to avoid confusing about them being serious ones. Signed-off-by:
-
jogo authored
ld-musl-*.so* is a symlink "broken" for the hostsystem, so wildcard will skip it, causing LD_MUSL_NAME to empty and the ldd symlink pointing to ../../lib directly. This causes sysupgrade failing to copy any linked libaries and consequently failing to run anything after switching to ram disk. Fix this by creating a symlink directly pointing to where ld-musl-*.so* points to. Signed-off-by:
-
blogic authored
Update nf_conntrack_rtsp to latest version based on http://mike.it-loops.com/rtsp/ (rtsp-module-3.7-v2.tar.gz). Signed-off-by:
Álvaro Fernández Rojas <noltari@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43311 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
* fixes a bug in multipart sms * adds a new call to read the sim phone number (partially functioanl) Signed-off-by:
John Crispin <blogic@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43310 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
musl libc doesn't support the GNU getopt extension to parse non-option arguments when the optstring starts with '-'. This extension is used by some utilities, notably iptables, that currently return with errors even with perfectly valid invocations. The patch adds the code needed by getopt.c and getopt_long.c to implement that extension. Signed-off-by:
-
blogic authored
This patch adds 3.14 kernel support for the mpc85xx platform. Works fine here with a TL-WDR4900 which seems to be the only supported device using this platform. There might be differences depending on HW version, therefore I'd ask others to test too. Changes to 3.10 missing config options added to 3.14 config file patch 001: rebased patch 100: rebased patch 110: rebased patch 120: rebased patch 130: rebased patch 140: minor adjustment patch 200: removed, change went upstream patch 210: rebased patch 220: removed, change went upstream patch 750: new, fixes an issue with ethernet port autoneg being disabled due to changes in kernel phy handling Signed-off-by: -
blogic authored
Signed-off-by:
Jacek Kikiewicz <jaceq@aol.pl> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43307 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Signed-off-by:
Roger Pueyo Centelles <roger.pueyo@guifi.net> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43306 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
still no sound but the codec is properly detected now, powers up and i can hear noise on the speakers. Signed-off-by:
-
blogic authored
Signed-off-by:
-
blogic authored
hardware status and tx vlan offload support on all targets except rt5350. so i modify the IS_ENABLE condition only for mt7621. support mt7621 hardware status reference by SDK. but i don't have mt7621. if not work just set mt7621 FE_REG_FE_COUNTER_BASE to 0 to let software count. Signed-off-by:
michael lee <igvtee@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@43303 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Signed-off-by:
-
blogic authored
hardware tx vlan offload only support max 16 vids now use add/delete vlan interface to update vlan id table when duplicate vlan id index detect. disable hardware tx vlan offload support. Signed-off-by:
-
blogic authored
Signed-off-by:
-
