- May 06, 2013
-
-
blogic authored
Signed-off-by:
John Crispin <blogic@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36566 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Signed-off-by:
Serge Vasilugin <vasilugin@yandex.ru> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36565 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
These devices are actually built around the 8devices Carambola dev board. ARC FreeStation, Flex mARC, iFlex, and SplitStation devices are supported with this image, see "ARCFlex Firmware Downloads": http://www.antennas.com/wiki/index.php?title=ARC-OS_Firmware_Downloads_and_Revision_History Funnily enough if present the external USB wlan ends up being wlan-0, with the SoC device being wlan-1. - Invert port map so special handling of vlan config can be removed. - Add LED config similar to original ArcOS firmware. - Add GPIO export for enabling PoE passthrough from ethernet port 0 to port 1 - Get MACs from factory partition. - Update description to list supported devices. - Carambola uses RT3050 (not RT3052), though my Carambola CPU actually reports itself as being an RT3350 while still having RT3050F markings. Signed-off-by:
Tobias Diedrich <ranma+openwrt@tdiedrich.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36564 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Support setting active_low in devicetree gpio-export. Signed-off-by:
-
blogic authored
Signed-off-by:
-
blogic authored
make banks 0 based to unbreak userland ABI Signed-off-by:
-
blogic authored
Signed-off-by:
-
blogic authored
Signed-off-by:
-
blogic authored
Fix DIR-620D1 flash size. Signed-off-by:
-
nbd authored
Signed-off-by:
Felix Fietkau <nbd@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36556 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
cyrus authored
Previously if the upstream router did not provide any DHCPv6-service the wan6 interface would not come up even if RAs were received. The new behavior allows the wan6 interface to comeup with RA-only configuration after a timeout of 10s. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36555 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jow authored
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36554 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jow authored
base-files: change network_find_wan() procedure to ignore default gateways in different routing tables git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36553 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jow authored
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36552 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
- May 05, 2013
-
-
luka authored
Signed-off-by:
Luka Perkov <luka@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36550 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
Signed-off-by:
-
- May 04, 2013
-
-
nbd authored
Signed-off-by:
-
nbd authored
Signed-off-by:
-
blogic authored
this should fix the handling of corner cases Signed-off-by:
-
- May 03, 2013
-
-
juhosg authored
Signed-off-by:
Gabor Juhos <juhosg@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36542 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
juhosg authored
AP135 has a pluggable PCIE slot unlike AP136. Signed-off-by:
Sujith Manoharan <c_manoha@qca.qualcomm.com> Signed-off-by:
-
luka authored
Signed-off-by:
-
luka authored
Signed-off-by:
-
luka authored
Signed-off-by:
-
nbd authored
Signed-off-by:
-
nbd authored
Signed-off-by:
-
nbd authored
ar71xx: add an external reset callback for ar913x and use it in ath9k - should reduce the frequency of DMA stop failures Signed-off-by:
-
- May 02, 2013
-
-
nbd authored
Signed-off-by:
-
jogo authored
Make SMP a subtarget, since it only supports BCM6362 and BCM6368. Signed-off-by:
Jonas Gorski <jogo@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36527 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jogo authored
BCM6358 requires further work due to its shared TLB. Signed-off-by:
-
jogo authored
/proc/irq is needed for changing the SMP affinity of interrupts. Signed-off-by:
-
jogo authored
Use busnum 1 for HSSPI so it won't conflict on chips having both SPI controllers. Signed-off-by:
-
jogo authored
Signed-off-by:
Daniel Gonzalez <dgcbueu@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36523 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
nbd authored
scripts/config: fix an option processing error that caused duplication in diffconfig.sh output (#13384) Signed-off-by:
-
jow authored
- assume "tcp+udp" if no protcol is specified in rules or redirects (#13422, #13386) - add support for fwmark matches and mark setting targets git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36521 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jow authored
- copy permission of config files to state files to allow access to state info by non root users - properly handle empty string case when unsetting lists git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36518 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
nbd authored
Signed-off-by:
-
jow authored
atheros: remove static gpio_request() from board setup and include generic kmod-gpio-button-hotplug instead. This change is based on a patch by Karl Palsson <karlp@remake.is> See http://patchwork.openwrt.org/patch/3536/. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36513 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jow authored
In my machine, the file is created with arptable_filter before arp_tables. This can't happen because the former depends on the latter. So, instead of rely on wildcards (*.ko), set by hand the files to be loaded in the correct order. Signed-off-by:
Jonh Wendell <jonh.wendell@oiwifi.com.br> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36512 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jow authored
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@36511 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
