- Sep 13, 2013
-
-
juhosg authored
Signed-off-by:
Gabor Juhos <juhosg@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37975 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
juhosg authored
- change patch numbers to group the related stuff together, - add mtd prefix where it is missing, - use hyphens in the patch names Signed-off-by:
-
juhosg authored
Signed-off-by:
-
juhosg authored
Signed-off-by:
-
juhosg authored
Signed-off-by:
-
hauke authored
Most of the Linksys devices without an own GPIO configuration where detected as WRT54G. On one board this made OpenWrt to boot into failsafe every time, because one GPIO configurated as button was not a button. Signed-off-by:
Hauke Mehrtens <hauke@hauke-m.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37970 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
hauke authored
Thanks Devastator for testing git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37969 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
juhosg authored
Signed-off-by:
-
juhosg authored
Signed-off-by:
-
juhosg authored
Signed-off-by:
-
juhosg authored
Squashfs is unable to decompress some blocks without that: [ 0.970000] SQUASHFS error: xz_dec_run error, data probably corrupt [ 0.980000] SQUASHFS error: squashfs_read_data failed to read block 0x29a72 [ 0.990000] SQUASHFS error: Unable to read fragment cache entry [29a72] [ 1.000000] SQUASHFS error: Unable to read page, block 29a72, size 14c50 [ 1.010000] SQUASHFS error: Unable to read fragment cache entry [29a72] [ 1.020000] SQUASHFS error: Unable to read page, block 29a72, size 14c50 [ 1.260000] SQUASHFS error: xz_dec_run error, data probably corrupt Signed-off-by:
-
juhosg authored
This patch adds support for building firmware images for the TP-Link TL-MR3040 v2. Tested and working on v2.1 hardware. Signed-off-by:
Mads Hansen <d@taba.se> Signed-off-by:
-
juhosg authored
I checked the GPL code drop from D-Link and tried to get the wireless and LAN switch LEDs to light up. I found some references in AthSDK/www/DIR-825_C1/bsp.h as well as AthSDK/www/DIR-825_C1/rootfs/etc/sysconfig/S2gpio.sh, but in the end I only got the led for 2.4GHz to work. Anyway, here's the patch. Signed-off-by:
Sebastian Kemper <sebastian_ml@gmx.net> Signed-off-by:
-
jow authored
- fixes buffer corruption with JSON-RPC list calls - change JSON-RPC protocol to include the session ID into the call attributes instead of passing it via the URL - forcibly pass effective session ID as "ubus_rpc_session" attribute to called procedures - change ubus acl checking to conform with new ubus session namespace git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37962 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jow authored
- recalculate session ACLs on reload - support negative access group expressions in /etc/config/rpcd - prevent destryoing the default session - use "ubus_rpc_session" attribute as session identifier to enforce JSON-RPC proxy security git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37961 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
luka authored
Signed-off-by:
Luka Perkov <luka@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37960 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
hauke authored
Signed-off-by:
-
hauke authored
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37958 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
hauke authored
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37957 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
- Sep 12, 2013
-
-
luka authored
Signed-off-by:
Flavio Silveira <fggs@terra.com.br> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37956 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
cyrus authored
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37951 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
luka authored
The imx sata module has only been backported to imx6 target. This change will fix buildbot errors due to missing patches in other targets. Keep this until all targets use kernel version with imx sata support in them. Signed-off-by:
-
- Sep 11, 2013
-
-
nbd authored
The skb is usually started by a padding which allows the protocols in the network stack to add their headers in front of the payload. The skb can be reallocated in case the preallocated padding is not large enough. This can for example happen in the function __skb_cow which will check the requested extra headroom and allocate more buffer when the requested headroom is bigger than the available one. The extra buffer is aligned again to the multiple of the NET_SKB_PAD of the target architecture. The macro used to create the multiple of the NET_SKB_PAD is written in a way which allows only values power two as alignment parameter. The currently used value of 48 bytes can not be written as n ** 2 but as 2 ** 4 + 2 ** 5. The extra buffer is therefore not always the multiple of 48 but can be 16, 64, 80, 128, 144 and so on. The generated values are also not monotonic (48 requested bytes are mapped to 80 allocated bytes and 49 requested bytes are mapped to 64 allocated bytes). These unexpected small values result in more reallocations of the buffer. This was noticed prominently during tests between two QCA9558 720 MHz devices which were connected via ethernet to PCs and had a HT40 802.11n 3x3 link between each other. The throughput PC-to-PC during iperf TCP runs increased reliable from 186 Mibit/s to 214 Mibit/s in one direction and from 195 Mibit/s to 220 Mibit/s in the other direction. This is a performance increase of ~14% just by reducing the amount of reallocations. Signed-off-by:
Sven Eckelmann <sven@open-mesh.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37948 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
nbd authored
Signed-off-by:
Felix Fietkau <nbd@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37947 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
nbd authored
Signed-off-by:
-
kaloz authored
Signed-off-by:
Imre Kaloz <kaloz@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37945 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
kaloz authored
Signed-off-by:
-
kaloz authored
Signed-off-by:
-
florian authored
Signed-off-by:
Florian Fainelli <florian@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37942 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jow authored
- introduces persistent null session to allow access to procedures without login - implements session.login procedure to support user logins via json-rpc git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37941 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
florian authored
Backport an upstream patch to fix FIQ code on VIVT CPUs Signed-off-by:
-
florian authored
Signed-off-by:
-
florian authored
SPARC builds are currently broken because we do not define the MUSL dynamic linker name, fix that. Signed-off-by:
-
luka authored
Signed-off-by:
Tim Harvey <tharvey@gateworks.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37937 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
luka authored
Signed-off-by:
-
luka authored
Signed-off-by:
-
luka authored
Signed-off-by:
-
luka authored
- enable using hwmon GSC driver on all targets - add a kmod package for it Signed-off-by:
-
- Sep 10, 2013
-
-
nbd authored
gcc 4.6 miscompiles hostapd with mips16, on gcc 4.8 it works Signed-off-by:
-
nbd authored
Currently, the module causes an oops at least on rt5350. These patches have been accepted upstream at: git://git.kernel.org/pub/scm/linux/kernel/git/davem/net.git Signed-off-by:
Daniel Gimpelevich <daniel@gimpelevich.san-francisco.ca.us> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@37931 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
