- Aug 25, 2015
-
-
Gabriel Detraz authored -
rmilecki authored
We sill don't use kernel 4.2 which is required for backporting using upstream NVRAM support patch. Signed-off-by:
Rafał Miłecki <zajec5@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46724 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
nbd authored
Signed-off-by:
Felix Fietkau <nbd@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46723 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
nbd authored
gcc 4.4 was removed in r44957 gcc: remove 4.4.7 (only used by avr32) gcc 4.5 was removed in r36149 Signed-off-by:
Dirk Neukirchen <dirkneukirchen@web.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46722 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
nbd authored
A call to pskb_may_pull() might reallocate skb->data. Therefore we should only assign the src-pointer after any potential reallocations. Signed-off-by:
Linus Lüssing <linus.luessing@c0d3.blue> Signed-off-by:
-
nbd authored
This reverts commit a080e8e1. It did not fix the problem but just hid some symptom. The real issue was that IGMP/MLD report suppression was not considered for the multicast-to-unicast feature. A recent netifd which isolates IGMP/MLD reports between STAs by utilizing AP-isolation and bridge-hairpinning should have fixed this. It is perfectly fine to apply multicast-to-unicast to IPv6 Neighbor Solicitations, too (once that feature is configured correctly). Signed-off-by:
-
nbd authored
Signed-off-by:
-
cyrus authored
Signed-off-by:
Steven Barth <steven@midlink.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46718 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
- Aug 24, 2015
-
-
cyrus authored
Signed-off-by:
-
cyrus authored
Signed-off-by:
-
- Aug 23, 2015
-
-
jogo authored
Remove 131-MIPS-export-get_c0_perfcount_int.patch which was already applied in 4.1.6. This fixes the following build error: arch/mips/ath79/setup.c:217:77: error: redefinition of '__kstrtab_get_c0_perfcount_int' arch/mips/ath79/setup.c:211:77: note: previous definition of '__kstrtab_get_c0_perfcount_int' was here arch/mips/ath79/setup.c:217:350: error: redefinition of '__ksymtab_get_c0_perfcount_int' arch/mips/ath79/setup.c:211:350: note: previous definition of '__ksymtab_get_c0_perfcount_int' was here scripts/Makefile.build:258: recipe for target 'arch/mips/ath79/setup.o' failed Reported-by: swalker Signed-off-by:
Jonas Gorski <jogo@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46715 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
jogo authored
Fix patches not applying anymore since r46654. Signed-off-by:
-
jogo authored
Changelog: * https://www.kernel.org/pub/linux/kernel/v4.x/ChangeLog-4.1.6 Signed-off-by:
-
jogo authored
Properly treat -ENOSYS as no PHY, else ehci-orion won't work without generic phy support. Signed-off-by:
-
jogo authored
The ipw2x00 drivers assume that the system they are running is little endian, and access everything in native byte order. When run on a big endian system, everything breaks apart. Since fixing this is non trivial on a first glance, disable them for big endian targets. Signed-off-by:
-
jogo authored
Some CFEs seem to misconfigure the mapped memory flash access with fast read but without a dummy byte, causing all accesses to be prefixed with 0xff. This of course breaks reading out the nvram, so do not just move back to single i/o accessors, but also ensure that the dummy byte is correctly set. Signed-off-by:
-
jogo authored
Add a switch to scripts/feeds that allows listing the feeds with their currently checked out revisions in feeds.conf compatible format. This allows providing a feeds.conf for public builds to make replication of the build easier. Signed-off-by:
-
- Aug 22, 2015
-
-
Gabriel Detraz authored
-
- Aug 21, 2015
-
-
wigyori authored
Signed-off-by:
Zoltan HERPAI <wigyori@uid0.hu> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46705 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
wigyori authored
Signed-off-by:
-
wigyori authored
Signed-off-by:
-
wigyori authored
Signed-off-by:
Daniel Golle <daniel@makrotopia.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46702 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
wigyori authored
platforms. As there is no single config symbol deciding whether libahci.ko is being built or not it seems the most sensitive thing to package it in kmod-ata-core. Signed-off-by:
-
kaloz authored
problems. Now that the switch driver can handle two devices with the same MAC address in separate VLANs we can go back to using the same address on both interfaces. This is the Linksys firmware's default behavior. Signed-off-by:
Claudio Leite <leitec@staticky.com> Signed-off-by:
Imre Kaloz <kaloz@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46700 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
kaloz authored
a single database in the ATU. This created problems in the case of a system where two ports/devices share a MAC address (e.g. Linksys WRT1900AC eth0/eth1). This also clears any bootloader-set FDB defaults. This had caused issues creating port-based VLANs when mappings overlapped previous VLANs. Packets destined to a port not in the default port group flooded all ports. Tested on a 88E6171 (Linksys EA4500) and 88E6172 ('1900AC) Signed-off-by: -
kaloz authored
Thanks Sebastian for spotting it. Signed-off-by:
-
wigyori authored
Signed-off-by:
-
- Aug 20, 2015
-
-
cyrus authored
Signed-off-by:
-
- Aug 19, 2015
-
-
kaloz authored
Signed-off-by:
-
kaloz authored
The u-boot boot counter was never reset after a successful boot, which sometimes could make some variables become out of sync. This patch adds support for the boot counter and enables auto_recovery unconditionally. Signed-off-by:
Rob Mosher <nyt-openwrt@countercultured.net> Signed-off-by:
-
kaloz authored
Signed-off-by:
-
- Aug 18, 2015
-
-
kaloz authored
Signed-off-by:
-
cyrus authored
Signed-off-by:
-
cyrus authored
Signed-off-by:
-
cyrus authored
Packages that depend on PolarSSL fail to build because polarssl's InstallDev section never actually gets executed because (prior to this patch) the package name does not match the subdir the package is in (presumably due to upstream name change). As a workaround I have changed the package name back to polarssl and used a new variable SRC_PKG_NAME for the purposes of downloading the upstream tarball and creating PKG_BUILD_DIR. Signed-off-by:
Daniel Dickinson <openwrt@daniel.thecshore.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46683 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
- Aug 17, 2015
-
-
hauke authored
firmware is not available in linux-firmware yet so use official driver source Signed-off-by:
-
jow authored
Signed-off-by:
Jo-Philipp Wich <jow@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46677 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
The patch submitted in [46649] was mangled in the use of gmails webmail interface, tabs replaced with spaces, resulting in a patch which dit not apply. This should fix the issue, sorry for the noise. Signed-off-by:
Ben Whitten <benwhitten@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46676 3c298f89-4303-0410-b956-a3cf2f4a3e73
-
blogic authored
no-op since 2.6.35 removed in Kernel 4.1 see https://lwn.net/Articles/380931/ Signed-off-by: -
blogic authored
no-op since 2.6.35 removed in Kernel 4.1 see https://lwn.net/Articles/380931/ Signed-off-by:
-
